Pipeline string parallel experimental device

1. Operating environment: temperature 0-40 ° C, relative humidity: ≤90%RH, power supply: 220V/50Hz. Can be continuously operated.

2. Silent water pump, traffic: 20L/min, r--sing: 15m, power: 200W.

3. Experimental pipeline: m20 mm, ф25 mm, ф32 mm, each of each, long: 1000 mm, organic glass.

4. Water storage tank: 100L, material PVC board.

5. Measurement slot: Transparent and organic glass, 10L, with a scale.

6. All valves are the copper gate valve, which can be used to connect and connect the conversion of parallel and adjust the flow.

7. The pressure measurement meter is fixed on the measurement rack with 8 organic glass tubes with diameter φ8mm. The measured ruler is sticky on the pressure rack to facilitate readings. The indicator liquid in the pressure difference is water, which is non -toxic and safe.

8. The fluid-water used in the experiment is designed with a full-cycle, which fully saves water resources.

9. The frame and countertop are made of 304 st--nless steel. The structure is compact, the appearance is beautiful, and the operation is convenient.

10. Dimensions: 1600 × 550 × 2000mm (length × width × height), the frame is a mobile design, with a foot wheel and imprisoned feet.

1. Product introduction

It is constructed by BYD E5 electric drive system, including driving motors, gearboxes, P gear motors, vehicle speed sensors, differentials, water temperature sensors, etc., equipped with spraying ink, assembly with protection function detection terminals, can measure voltage, measured voltage, can measure voltage. Drise, waveform and other signals. Applicable to the teaching and tr--ning of the BYD E5 electric drive system for the high vocational colleges, technical colleges, and new energy tr--ning institutions.

2. Functional characteristics

1. Learn to understand the structure and working principle of BYD E5 power assembly.

2. The tr--ning desk can simulate the BYD E5 permanent magnet synchronous motor acceleration, deceleration, braking, reversing and other operating conditions to observe the working status of the motor under the corresponding conditions.

3. Directly observe the cooling water temperature sensor of the permanent magnet synchronous motor, and differential wheel speed sensor.

4. Directly observe the principles and work processes of the P gear motor.

5. Three -phase sine waveforms that can be measured on the panel can be measured on the working output of the permanent magnet synchronous motor, which can measure the electrical signal of the spin -changing sensor.

6. Measure the speed sensor on the panel, the resistance value of the water temperature sensor, the classification of each sensor, the characteristics of the component, and the working principle.

7. Learn the working principle of the car differential, understand the structure of the car differential, and master its working principle.

8. You can analyze the circuit with reference to the original m--ntenance manual or circuit diagram.

9. Machinery assembly and fitter assembly virtual simulation software: This software is developed based on Unity3D. It can select 6 -level image quality. It has the design and virtual disassembly of the reducer and shaft structure, the design and simulation of common mechanical institutions, institutional resource libraries, institutional resource libraries. Typical mechanical institutions (virtual disassembly of gasoline engines), software is an overall software, which cannot be separate resources.

A. Turbine design and virtual disassembly interface can be selected from turbine sn--l pole cone gear reducer, second -level pilot gear reducer, conical cylindrical gear reducer, coaxial cylindrical gear reducer, cone gear reducer, first -class cylindrical, first -class cylindrical, Gear reducer.