Manual transmission flip training device

(2) Rotate the gear transmission at any angle and lock it at arbitrarily to facilitate disassembly and assembly from different angles.

(3) Place the oil disk at the bottom to facilitate the centralized storage of small parts or screws.

(4) The turning rack is welded with high -intensity steel structure, and the surface is treated with spraying process. There is a self -locking foot wheel at the bottom of the flipper, which can move.

(5) Dimensions: 1000 × 600 × 1100mm (length × width × height)

Basic configuration (each)

Number of serial number name specifications

1 Anatomical manual transmission assembly renovation set 1 1

2 turning rack (with a self -locking wheel device) 950 × 680 × 850mm (length × width × height) platform 1

Technical Parameters:

1. Operating environment: temperature 0-40 ° C, relative humidity: ≤90%RH, power supply: 220V/50Hz. Can be continuously operated.

2. The centrifugal pump uses a pipeline centrifugal pump, the rated power: 370W, speed: 2800r/min, suction: 8m, efficiency: 34%, traffic: 2.5m3/h, r--sing: 15m, wide experimental range, can obviously appear empty, can obviously appear empty, can obviously appear empty, can obviously appear empty, which can obviously appear empty to occur. Steaming phenomenon, 2 units.

3. Pressure gauge: dial diameter φ100mm, measurement range 0-0.4MPa, accuracy of 1.5 level.

4, vacuum table: dial diameter φ100mm, measurement range -0.1-0MPa, accuracy of 1.5.

5. The motor power is measured by digital single -phase AC power measuring instruments.

6. Flow meter flow meter: 0-6 m3/h. Blinding range: 10 ~ 150kPa.

7. Water storage tank: The volume is about 70L, and 304 st--nless steel is made of. When the water supply is stopped to open the pump valve, it can cause the pump when the pump is running.

8. The fluid-water used in the experiment is designed with a full-cycle, which fully saves water resources.

9. Electric control box, equipped with switch indicators and power tables, display the power of the pump.

10. The frame and countertops are made of 304 st--nless steel. The structure is compact, the appearance is beautiful, and the operation is convenient.

11. Dimensions: 1650 × 600 × 1500mm (length × width × height), the frame is a mobile design, with a foot wheel and imprisoned feet.

12. Building building and smart building electrical installation virtual simulation software

Based on the UNITY3D design, users choose different interactive interface size based on the computer configuration. The software in the software can be rotated, magnified, reduced, and translated at 360 °. There are small assistant tips for software use, the content is as follows:

A. Wet alarm system

1. System summary: Overview of Wet Alarm System

2. Equipment cognition: there are ** perspectives, equipment det--ls (displayed or parameters of the device), practice (built -in 6 selection questions, there are prompts for correctness and errors), schematic diagrams (can be entered from the schematic diagram Go to the device). The equipment includes: nozzle, water flow indicator, signal butterfly valve, exhaust valve, fire alarm control, executive pressure gauge, high water tank, Weia control cabinet, stabilization tank, flow switch, end -end water testing device, dr--nage facility, water pump combinations, water pump combination Instruments, hydraulic bells, latencys, wet alarms, butterfly valves, stop valves, fire pumps, safe stabilization valves, fire pools.